All stock codes associated to this product
KVR13R9D4K2/32I, 1983417, 740617205299
KVR13R9D4K2/32I
- 32GB (16GB 2G x 72-Bit x 2 pcs.) PC3-10600
- CL9 Registered w/Parity 240-Pin DIMM Kit
DESCRIPTION
ValueRAM's KVR13R9D4K2/32I is a kit of two 2G x 72-bit (16GB) DDR3-1333 CL9 SDRAM (Synchronous DRAM), registered w/parity, Intel® Compatibility Tested, 2Rx4 ECC memory modules, based on thirty-six 1G x 4-bit FBGA components per module. Total kit capacity is 32GB. The SPDs are programmed to JEDEC standard latency DDR3-1333 timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows:
SPECIFICATIONS
CL(IDD) |
9 Cycles |
Row Cycle Time (tRCmin) |
49.5ns (min.) |
Refresh to Active/Refresh
Command Time (tRFCmin)
|
260ns (min.) |
Row Active time (tRFCmin) |
36ns (min.) |
Maximum Operating Power |
6.411 W* (per module) |
UL Rating |
94 V - 0 |
Operating Temperature |
0 to 85 Degrees Celcius |
Storage Temperature |
-55 to 100 Degrees Celcius |
*Power will vary depending on the SDRAM and Register/PLL used.
FEATURES
- JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
- VDDQ = 1.5V (1.425V ~ 1.575V)
- 667MHz fCK for 1333Mb/sec/pin
- 8 independent internal bank
- Programmable CAS Latency: 9, 8, 7, 6
- Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
- Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)
- 8-bit pre-fetch
- Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
- Bi-directional Differential Data Strobe
- Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
- On Die Termination using ODT pin
- On-DIMM thermal sensor (Grade B)
- Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C
- Asynchronous Reset
- PCB : Height 1.180” (30.00mm), double sided component