All stock codes associated to this product
BX650CI, UPAPCBX650CI, 731304285083
Back-UPS
APC Back-UPS 650VA, AVR, 230V
APCBack-UPS,390 Watts /650 VA,Input230V /Output230V
Includes: Qty 1 - Detachable 1.2 m IEC power cord, User Manual
BX650CI
Product Overview
BX650CI Features
Battery failure notification
Provides early-warning fault analysis on batteries enabling timely preventive maintenance
Resettable circuit breaker
Easy recovery from overloads; no need to replace a fuse.
Cold-start capable
Provides temporary battery power when the utility power is out.
Disconnected battery notification
Warns when a battery is not available to provide backup power.
Audible alarms
Provides notification of changing utility power and UPS power conditions
Intelligent battery management
Maximizes battery performance, life, and reliability through intelligent, precision charging.
Automatic Voltage Regulation (AVR)
Automatically steps up low voltage and steps down high voltage to levels that are suitable for your equipment.
Back-UPS Features & Benefits
Battery and surge protected outlets
Back up and protect your hardware and data during power outages, surges and spikes.
Surge only outlets
Protect secondary electronics from surges and spikes without reducing battery power used to run primary electronics during an outage.
Automatic self-test
Periodic battery self-test ensures early detection of a battery that needs to be replaced.
Battery failure notification
Provides early-warning fault analysis on batteries enabling timely preventive maintenance
Intelligent battery management
Maximizes battery performance, life, and reliability through intelligent, precision charging.
Resettable circuit breaker
Easy recovery from overloads; no need to replace a fuse.
Audible alarms
Provides notification of changing utility power and UPS power conditions
LED status display
Quickly understand unit and power status with visual indicators.
Safety-agency approved
Ensures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.
Specifications:
Output Power Capacity
390Watts /650 VA
Max Configurable Power
390Watts /650 VA
Nominal Output Voltage
230V
Efficiency at Full Load
97.0%
Output Frequency (sync to mains)
50/60Hz +/- 3 Hz
Topology
Line Interactive
Waveform Type
Stepped approximation to a sinewave
Output Connections
(4) IEC 320 C13 (Battery Backup) |
|
(1) IEC Jumpers (Battery Backup) |
|
Efficiency at Half Load
95.0%
Nominal Input Voltage
230V
Input Frequency
45 - 65 Hz
Input voltage range for main operations
140 - 300V
Input Breaker Capacity
7.0A
Battery Type
Maintenance-free sealed Lead-Acid battery with suspended electrolyte : leakproof
Typical recharge time
8hour(s)
Replacement Battery
APCRBC110
Hover over the line on the graph above to view the runtime at any desired load
Curve fit to measured runtime data. All measurements taken with new, fully charged batteries, at typical environmental conditions, with no electrical input and balanced resistive load (PF = 1.0) output.
View Enlarged Graph
View Runtime Chart
Communications & Management
Control panel
LED status display with On Line : On Battery : Replace Battery and Overload indicators
Audible Alarm
Alarm when on battery : distinctive low battery alarm : overload continuous tone alarm
Surge Protection and Filtering
Surge energy rating
273Joules
SCC Codes
1073130428508 0
Operating Environment
0 - 40C
Operating Relative Humidity
0 - 95%
Operating Elevation
0-3000meters
Storage Temperature
-15 - 45C
Storage Elevation
0-9000meters
Audible noise at 1 meter from surface of unit
45.00dBA
Regulatory Approvals
CE, EN/IEC 60950-1, GOST, NEMKO
Standard Warranty
2 years repair or replace
REACH
REACH: Contains No SVHCs