All stock codes associated to this product
HX424C15FW2/8, 3603949, 740617266900
Kingston HX424C15FW2/8 8GB 1G x 64-Bit DDR4-2400 CL15
288-Pin DIMM
Description
HyperX HX424C15FW2/8 is a 1G x 64-bit (8GB) DDR4-2400 CL15 SDRAM (Synchronous
DRAM) 1Rx8, memory module, based on eight 1G x 8-bit FBGA components per module.
Each module supports Intel Extreme Memory Profiles (Intel XMP) 2.0. Each module
has been tested to run at DDR4-2400 at a low latency timing of 15-15-15 at 1.2V.
Additional timing parameters are shown in the Plug-N-Play (PnP) Timing
Parameters section below. The JEDEC standard electrical and mechanical
specifications are as follows:
PnP JEDEC TIMING PARAMETERS:
- JEDEC: DDR4-2400 CL15-15-15 @1.2V, DDR4-2133 CL14-14-14 @1.2V
- XMP Profile #1: DDR4-2400 CL15-15-15 @1.2V
Features
- Power Supply: VDD = 1.2V Typical
- VDDQ = 1.2V Typical
- VPP - 2.5V Typical
- VDDSPD = 2.25V to 3.6V
- Nominal and dynamic on-die termination (ODT) for data, strobe, and mask
signals
- Low-power auto self refresh (LPASR)
- Data bus inversion (DBI) for data bus
- On-die VREFDQ generation and calibration
- Single-rank
- On-board I2 serial presence-detect (SPD) EEPROM
- 16 internal banks; 4 groups of 4 banks each
- Fixed burst chop (BC) of 4 and burst length (BL) of 8 via the mode
register set (MRS)
- Selectable BC4 or BL8 on-the-fly (OTF)
- Fly-by topology
- Terminated control command and address bus
- Height 1.340 (34.04mm), w/o heatsink
Specifications
CL(IDD) |
15
cycles |
Row Cycle Time
(tRCmin) |
45.25ns(min.) |
Refresh to
Active/Refresh |
350ns(min.) |
Command Time
(tRFCmin) |
|
Row Active Time
(tRASmin) |
29.125ns(min.) |
Maximum Operating
Power |
TBD
W* |
UL
Rating |
94 V -
0 |
Operating
Temperature |
0 DegreeC to +85
DegreeC |
Storage
Temperature |
-55 DegreeC to +100
DegreeC |