KVR16LR11D8/8HD | Kingston 8GB (1x8GB) PC3L-12800 1600MHz Registered ECC DDR3L

Please choose carefully, we are unable to refund or exchange for incorrect choice. ECC memory is generally system/server specific and we recommend the use of our Kingston memory selector to ensure compatibility

Kingston KVR16LR11D8/8HD 8GB 2Rx8 1G x 72-Bit PC3L-12800 CL11 Registered w/Parity 240-Pin DIMM

Description

This document describes ValueRAM's 1G x 72-bit (8GB) DDR3L-1600 CL11 SDRAM (Synchronous DRAM), low voltage, registered w/parity, 2Rx8 ECC, memory module, based on eighteen 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.35V or 1.5V. This 240-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows:

Features

• JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) Power Supply
• VDDQ = 1.35V (1.28V ~ 1.45V and 1.5V (1.425V ~ 1.575V)
• 800MHz fCK for 1600Mb/sec/pin
• 8 independent internal banks
• Programmable CAS latency: 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (interleave without any limit, sequential with starting address 000 only), 4 with tCCD = 4 which does not allow seamless read or write (either on the fly using A12 or MRS)
• Bi-directional Differential Data Strobe
• Internal (self) calibration: Internal self calibration through ZQ pin (RZQ: 240 ohm 1%)
• On Die Termination using ODT pin
• On-DIMM thermal sensor (Grade B)
• Average Refresh Period 7.8us at lower than TCASE 85C, 3.9us at 85C < TCASE < 95C
• Asynchronous Reset
• PCB : Height 1.180" (30.00mm), double sided component

Specifications