All stock codes associated to this product
KVR13LR9S4L/8, 740617212495
Kingston KVR13LR9S4L/8 8GB 1Rx4 1G x 72-Bit PC3L-10600
CL9 Registered w/Parity 240-Pin DIMM
Description
This document describes ValueRAM's 1G x
72-bit (8GB) DDR3L-1333 CL9 SDRAM (Synchronous DRAM), low voltage, VLP,
registered w/parity, 1Rx4 ECC memory module, based on eighteen 1G x 4-bit FBGA
components. The SPD is programmed to JEDEC standard latency DDR3-1333 timing of
9-9-9 at 1.35V and 1.5V. This 240-pin DIMM uses gold contact fingers. The
electrical and mechanical specifications are as follows:
Features
- JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) Power
Supply
- VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)
- 667MHz fCK for 1333Mb/sec/pin
- 8 independent internal bank
- Programmable CAS Latency: 9, 8, 7, 6
- Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
- Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)
- 8-bit pre-fetch
- Burst Length: 8 (Interleave without any limit, sequential with starting
address 000 only), 4 with tCCD = 4 which does not allow seamless read or write
[either on the fly using A12 or MRS]
- Bi-directional Differential Data Strobe
- Internal(self) calibration : Internal self calibration through ZQ pin (RZQ
: 240 ohm 1%)
- On Die Termination using ODT pin
- On-DIMM thermal sensor (Grade B)
- Average Refresh Period 7.8us at lower than TCASE 85C, 3.9us at 85C <
TCASE < 95C
- Asynchronous Reset
- PCB : Height 0.740" (18.75mm), double sided component
Specifications
|
CL(IDD) |
9
cycles |
|
Row Cycle Time
(tRCmin) |
49.5ns
(min.) |
|
Refresh to
Active/Refresh |
260ns
(min.) |
|
Command Time
(tRFCmin) |
|
|
Row Active Time
(tRASmin) |
36ns
(min.) |
|
Maximum Operating
Power |
(1.35V) = 4.919
W* |
|
(1.50V) = 5.601 W*
|
|
UL
Rating |
94 V -
0 |
|
Operating
Temperature |
0 DegreeC to 85
DegreeC |
|
Storage
Temperature |
-55 DegreeC to +100
DegreeC |
