KHX13000D3LLK2/2GX | Kingston 2GB (2 x 1GB) PC3-13000 1625MHz DDR3 RAM - 7-7-7-20

Kingston 2GB (2 x 1GB) PC3-13000 1625MHz DDR3 RAM - 7-7-7-20 - HyperX, Intel XMP

 

DESCRIPTION:
Kingston's KHX13000D3LLK2/2GX is a kit of two 128M x 64-bit 1GB (1024MB) DDR3-1625 CL7 SDRAM (Synchronous DRAM) memory modules, based on eight 128M x 8-bit DDR3 FBGA components per module. Each module pair supports Intel® XMP (Extreme Memory Profiles). Each module pair has been tested to run at DDR3-1625MHz at a low latency timing of 7-7-7 at 1.9V. The SPDs are programmed to JEDEC standard latency DDR3-1066Mhz timing of 7-7-7 at 1.5V. Each 240-pin DIMM uses gold contact fingers and requires +1.5V. The JEDEC standard electrical and mechanical specifications are as follows:

FEATURES:
JEDEC standard 1.5V ± 0.075V Power Supply
VDDQ = 1.5V ± 0.075V
533MHz fCK for 1066Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 5,6,7,8,9,10
Posted CAS
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 7(DDR3-1066)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4
which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C
Asynchronous Reset
1066Mbps CL7 doesn’t have backward compatibility with 800Mbps CL5
PCB : Height 1.180” (30.00mm), single sided component