All stock codes associated to this product
CLW141PL12TRA, CL-W141-PL12TR-A, II32393
Thermaltake CL-W141-PL12TR-A V-Tubler PETG Tube 12mm OD
10mm ID 500mm 4 Pack
Overview
Thermaltake V-Tubler PETG Tube 12mm OD 10mm ID 500mm 4
Pack
Thermaltake introduces the V-Tubler PETG solid tubing for custom PC water
cooling configurations. Manufactured from premium PETG, the V-Tubler rigid
tubing allows users to route the tubes runs exactly to their hearts content.
Designed with 12mm OD PETG tube adapter fittings, it gives users better
mounting, easier fitting, and ideal flow to make your system a showcase for all
to see.
Tt LCS Certified
Tt LCS Certified is a Thermaltake exclusive certification applied to only
products that pass the design and hardcore enthusiasts standards that a true LCS
chassis should be held to. The Tt LCS certification was created so that we at
Thermaltake can designate to all power users which chassis have been tested to
be best compatible with extreme liquid cooling configurations to ensure you get
the best performance from the best features and fitment.
100% PETG Material
Made in Taiwan, the V-Tubler PETG Tube is constructed from superior PETG
material which is reliable, non-toxic, and substance free. Thicker walls ensure
safe operation, enabling the users to make the straightest run as well as
tightest bends without the need of excessive compression fittings and 90 degree
angle rotaries. Working temperature ranges from -4 (-20) to 143.6 (62).
-
Outer Diameter: 12 mm
-
Inner Diameter: 10 mm
-
Length: 500mm*4
Remarkable Expansion
Designed for use with 12mm OD PETG tube adapter fittings,
V-Tubler PETG Tube is pre cut into retail coils of four 500mm lengths, allowing
enthusiasts to build up aesthetically-superior water cooling systems by
allocating the radiators to each particular component and incorporating
externally-modular upgrades for their chassis.
*Coolant operating temperature exceeds 50/122F may potentially
affect the PETG tube.
*Thermaltake
V-Tubler PETG Tube Series is recommended for use with the Pacific Temperature
Sensor.
Caution
Thermaltake recommends the following steps to be taken after
completing your water loop setup
- It is strongly recommended to use market proven pre-mix
coolant, such as Thermaltake Coolant 1000. It offers great performance while
preventing the entire cooling system copper, brass, nickel, aluminum, and
steel from corrosion.
- Fill the reservoir with coolant and cycle the power on and off
several times while the pump pushing the coolant into the loop.
- DO NOT let the pump run dry, when there is no liquid entering
the pump turn off your power immediately
- Fill the reservoir to the top as it will prevent air from
going into the pump
- If necessary tilt the system slightly from side to side to
bleed the air out of the loop.
- Place some paper towels under fittings and joining points to
test for leak.
- Run the loop with the fill port open for about 24 hours to
completely bleed the air out of the loop
- Before starting, flush out your system correctly to prevent
any coolant or unwanted particles sticking to your tubes, radiators and other
cooling components.
- Coolant might fade over time.
Specifications
Material |
PETG |
Inside
Diameter |
10
mm |
Outside
Diameter |
12
mm |
Length |
500 mm
*4 |
Color |
Transparent |