All stock codes associated to this product
UPD2018, USSUNUPD2018, USSUN-UPD2018, 4715109710953
Sunix UPD2018 USB 3.1 10G & DisplayPort Alt-Mode PCI Express Host
Card with Dual USB Type-C Receptacles (Gen2)
Overview
SUNIX UPD2018 is a Dual-port Super-Speed+ USB 3.1 10G PCI Express add-on
card, and its compliant with the PCI Express Gen3 specification for host PC
system. Based on USB Type-C pure DFP (Downstream Facing Port) mode, it works up
to 10 Gbps for data transfer when connecting to USB 3.1 compliant peripherals,
while maintaining compatibility with existing USB peripheral devices. USB 3.1
performance is 2 times faster than USB 3.0 and 20 times faster than USB 2.0
connectivity. In additional, one USB Type-C port supports DisplayPort
Alternate-mode for video output, and the other is an USB data-only
port.
With USB Type-C Receptacle, SUNIX UPD2018 supports reversible plug
orientation and cable direction, which means that users will no longer need to
be concerned with plug orientation/cable direction, making it easier to plug in.
The new connector is smaller and thinner design, but drive higher power output
capacity to USB device. SUNIX UPD2018 supports 5VDC@1500mA power output to USB
device with over current protection on each USB port. This card is an ideal
choice for external storage, smart phone, webcam, video devices, and all other
USB electronic devices.
- Works with Windows 7, Windows 8.x & Windows 10
- Works best with Windows 10
- Works limited with MacPro with latest Thunderbolt technology & all
firmware and drivers update (*please contact us for more updated supporting
info)
- Works with Wacom products with USB-C connection (*make sure you have the
latest firmware and drivers update from Wacom)
- Works with USB-C equipped 4K monitors
- Fits in any PCIe x1, x2, x4, x8, x16 slots
- Use only the bundled DP-to-DP cable
- Make sure the DisplayPort output from the source (host computer) is
DisplayPort v.1.2 or later
- For Video-output via USB-C port (only the middle USB port support
alt-mode; i.e. data+video)
- After installed UPD2018 drivers set, restarting your computer couple times
is required
- Make sure you are using a certified USB-C cable with the proper length;
recommended 1-meter; if you should need to use 1+ meter long USB-C cable, must
make sure the is USB-C certified; below some references on cable
spec.
Features
- PCI Express Base Specification Revision 3.0 single-lane (x1).
- Expands dual external USB 3.1 Super-Speed plus Type-C port (DFP) on the
system.
- Compliant with Universal Serial Bus 3.1 specification Gen2.
- Compliant with xHCI (eXtensible Host Controller Interface) specifications
Revision 1.1.
- Supports simultaneous operation of multiple USB 3.1, 3.0, USB 2.0 and USB
1.1 devices
- Supports USB data transfer rate of 10G/5G/480/12/1.5 Mbps.
- USB port supplies +5VDC / 1.5A power output to USB device with over
current protection.
- Compliant with DisplayPort 1.2 spec with HDTV 4K (2160p) resolution and
stereoscopic 3D.
- Compliant with VESA DisplayPort Alternate Mode for USB Type-C Standard
Rev1.0.
- Hot-swapping feature allows connect/disconnect device without powering
down the system.
- Driver supports for Microsoft Windows 7, 8.x, and 10 operation
systems.
- Certified by Electromagnetic Compatibility (CE, FCC, VCCI, BSMI) and RoHS
approval.
Specifications
Hardware |
|
BUS |
PCI Express Spec 3.0,
Single-Lane (x1) |
Controller |
PCI Express USB 3.1
Host controller, Asmedia ASM1142 |
USB
Standard |
eXtensible Host
Controller Interface (xHCI) Rev1.1 |
IRQ &
IO |
Assigned by
System |
USB
Communication |
|
Interface |
Universal Serial Bus
3.1 / 3.0 / 2.0 / 1.1 |
Speed |
Super Speed+ (10Gpbs),
Super Speed (5Gpbs), High Speed (480Mbps), Full Speed (12Mbps), Low Speed
(1.5Mbps) |
No. of
Port |
2-port |
PCB
Connector |
USB 3.1 USB Type-C port
(Downstream Facing Port) |
Protection |
15KV IEC61000-4-2 Air
Gap Discharge |
8KV IEC61000-4-2
Contact Discharge |
Video /
Audio |
|
Input
Interface |
Standard DisplayPort
Female, DisplayPort Ver1.2/1.1 |
Output
Interface |
USB Type-C
port |
Audio |
Yes (audio
pass-through) |
Power |
|
Source |
PCI Express Bus
Power |
Output
Capacity |
USB Type-C
Port: |
Power Delivery +5VDC /
1.5A / each port |
Note: Total power
output capacity will be limited by system power
supply. |
Over Current
Protection |
USB Type-C
Port: |
+5VDC / 1.5A / each
port / Power Switch |
Power
Consumption |
3.0W @ 3.3V (board only
without power output to USB device) |
Driver
Support |
|
Windows |
Windows 7
(X86/X64) |
Windows 8.x / 10
(X86/X64) (Windows in-box driver) |
Environment |
|
Operation
Temperature |
0 to 60C (32 to
140F) |
Operation
Humidity |
5 to 95%
RH |
Storage
Temperature |
-20 to 70C (-4 to
158F) |
Regulatory
Approvals |
|
EMC |
EUR: CE, EN55022 Class
B, EN55024, EN61000-3-2, EN61000-3-3 |
US: FCC Part 15 Class
B |
TAIWAN: BSMI:
CNS13438 |
AS/NZS: C-Tick:
CISPR22 |
JAPAN:
VCCI |
Green |
RoHS, CRoHS,
WEEE |
Physical
Characteristics |
|
PCB
Dimension |
85.30x 55.75
mm |
Bracket |
Standard 120 mm (Low
Profile 80mm) |
Bracket
Space |
1 |