All stock codes associated to this product
KVR13E9/2HC, XKVR13E9/2HC, 1995448, 740617206845
KVR13E9/2HC
2GB 1Rx8 256M x 72-Bit PC3-10600
CL9 240-Pin ECC DIMM
DESCRIPTION
This document describes ValueRAM's 256M x 72-bit (2GB) DDR3-1333 CL9 SDRAM (Synchronous DRAM), 1Rx8, ECC, memory module, based on nine 256M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1333 timing of 9-9-9 at 1.5V. This 240-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows:
FEATURES
- JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
- VDDQ = 1.5V (1.425V ~ 1.575V)
- 667MHz fCK for 1333Mb/sec/pin
- 8 independent internal bank
- Programmable CAS Latency: 9, 8, 7, 6
- Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
- Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)
- 8-bit pre-fetch
- Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or
MRS]
- Bi-directional Differential Data Strobe
- Thermal Sensor Grade B
- Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
- On Die Termination using ODT pin
- Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C
- Asynchronous Reset
- PCB: Height 1.18” (30mm), single sided component
SPECIFICATIONS
- CL(IDD): 9 cycles
- Row Cycle Time (tRCmin): 49.5ns (min.)
- Refresh to Active/Refresh: Command Time (tRFCmin): 160ns (min.)
- Row Active Time (tRASmin): 36ns (min.)
- Maximum Operating Power: 2.430 W*
- UL Rating: 94 V - 0
- Operating Temperature: 0o C to 85o C
- Storage Temperature: -55o C to +100o C
