Technical Specifications
Protocol/Standards
• HomePlug 1.0 specification, IEEE 802.3 10/100 Ethernet (100Mbps) and IEEE 802.3u Fast Ethernet Compliant
• 10/100 Mbps AutoMDI/MDIx Support
• 85Mbps Homeplug 1.0 compatible
• IEEE 802.11g Wireless Specifications
Range
• up to 300 meters via Wireless LAN (outdoor)
• up to 200 meters via homeplug
Transmission Rate
• up to 54Mbps via Wireless LAN G
• up to 85Mbps via homeplug
Modulation Support
• DSSS (Direct Sequence Spread Spectrum) Wireless LAN standard
• OFDM 256/64/16, DQPSK, DBPSK and ROBO Modulation Scheme
Frequency Band
• 4.3 Mhz to 20.9 Mhz band
Security
• WEP (Wired Equivalent Privacy) via Wireless LAN
• WPA (Wi-Fi Protected Access) via Wireless LAN
• 56 bit DES Encryption with key management for secure powerline communications (Web-based Configuration)
Wireless Mode
• Wireless Access Point (AP)
• Wireless Client
Homeplug Quality of Service
• Forward Error Correction (FEC) support
• Channel Adaptation ensures that signal integrity is maintained even under harsh noise environment
• CSMA/CA with prioritization and ARQ for reliable delivery of Ethernet packets via Packet Encapsulation
• Four Level prioritized random access method
• Segment bursting and contention-free access ensures high throughput while maintaining low latency response and jitter performance
Hardware
• Intellon INT5500 Integrated Single-chip Powerline Network Transceiver
• Intellon INT1200 Analog Front End IC
• Infineon Wildpass Wireless 11b/g chipset solution
Platform Support
• O/S Independent with TCP/IP protocol installed
• Configuration via Setup Utility (thru Homeplug and Ethernet only)
Power Supply
• Switch Mode 100V-240V Supply for worldwide plugs (Euro, US, UK and AUS)
LED Indicators:
• 1 x Power LED
• 1 x Powerline Link/Activity Status LED
• 1 x Ethernet Link/Activity Status LED
• 1 x Wireless LAN Activity Status LED
External Connectors:
• 1 x Electrical Power plugs
• 1 x RJ45 for 10/100 Ethernet (AutoMDI/MDI-X)
• 1 x Wireless Antenna (3dBi Dipole)
• 1 x Reset Button (default to Factory Settings)