|
General
|
| Dimensions (H x W x D, mm) |
800 x 600 x 200 |
| Weight (kg) |
50 |
| Warranty |
5 years |
| |
| Electrical |
| Input voltage |
380 - 440VAC 3 Phase |
| Max Continuous Voltage (Mcov) |
300VAC L-N |
| Temporary overvoltage - TOV |
320VAC, 15 mins |
| Service type |
TT, TN, TN C-S or any 3-phase system with a grounded neutral.
This unit must not be connected to an ungrounded system |
| Test classification |
Class II |
Energy Absorption rating - per mode (Joules)
Primary protection L-N:
Secondary protection L-N:
Common mode protection N-E:
Aggregate rating: |
CEi: 1,200J/ph, 3,600J total. DEi: 1,800J/ph, 5400J total. EEi: 3,600J/ph, 10,8000J total.
CEi: 600J/ph, 1,600J total. DEi: 600J/ph, 1,800J total. EEi: 600J/ph, 1,800J total.
CEi: 2,130J. DEi: 710J. EEi: 710J
CEi: 7,530J. DEi: 7,910J.. EEi: 13,310J. |
| Current rating continuous (standard models) |
100A |
| Recommended maximum over current protection |
100A |
| Residual current |
<1 mA |
| Short circuit withstand (1 sec) |
29kA |
| Protection modes |
Line-Neutral, Neutral-Earth |
| In 8/20us (Line-Neutral) Nominal Surge Life |
CEi: 30kA x 20 hits/ph; DEi: 45kA x 20 hits/ph; EEI: 90kA x 20 hits/ph |
| In 8/20us (Neutral-Earth) Nominal Surge Life |
45kA x 20 hits |
| Ismax 8/20us (Line-Neutral) Max surge level |
CEi: 80kA; DEi: 120kA; EEI: 240kA |
| Ismax 8/20us (Neutral-Earth) Max surge level |
CEi: 120kA; DEi: 40kA; EEI: 40kA |
| Filter attenuation |
70dB nominal above 1MHz |
| Initial clamp voltage (Line-Neutral) |
560V (350Vac RMS) |
| Initial clamp voltage (Line-Earth) |
1240V (700Vac RMS) |
| Initial clamp voltage (Neutral-Earth) |
680V (420Vac RMS) |
| Residual voltage (Vpl) Line-Neutral |
<900Vac (3kA, 8/20uS) IEC61643.1 |
| Residual voltage (Vpl) Line-Earth |
<1100Vac (3kA, 8/20uS) IEC61643.1 |
| Residual voltage (Vpl) Neutral-Earth |
<1000Vac (3kA, 8/20uS) IEC61643.1 |
| Internal protection (fusing) |
All surge diverter connections are fused via HRC fuses to IEC269-2-1 |
| Terminations |
Bolted lug. 8mm bolts for phase & neutral connections. 8mm PE (earth) stud provided on geartray. |
| |
|
Communications
|
| Alarms/indicators |
Mimic panel display via LED (2 colour), OK - Green; Protection Fault - Red. Dry contact alarm relay output 250Vac/32Vdc, 10A, 4kV isolation, Alarm under-voltage cutoff 180Vac |
| Environmental & Standards |
| Enclosure rating |
IP24 |
| Design standards |
IEC61643-1, IEC610006-1,2,3,4 ANSI/IEEE C62.41 Cat B,C,D AS1768-2007 Cat B,C,D,E AS3000, AS3100, CE mark |
| Environment |
-10 to 65C, 10 to 90%RH (non-condensing) |
