Looking for a videocard? In Stock Videocards One per customer please

Cisco WAP200E Wireless-G Exterior Access Point: PoE Cisco Small Business Access Points



High-Speed Wireless Access for Exterior Environments

  • Extends network to exterior business environments, keeping employees connected and productive
  • Features RangeBooster technology, which increases wireless throughput and range and reduces "dead spots" in the wireless coverage areas
  • Advanced wireless security protects network traffic to keep business assets safe
  • Weather-resistant housing, internal high-gain antennas, and Power over Ethernet simplify installations and expand placement options


The CiscoWAP200E Wireless-G Exterior Access Point (Figure 1) lets you connect Wireless-G (802.11g) or Wireless-B (802.11b) devices to your wired network, so you can add PCs to the network without the need for additional cabling. This weather-resistant access point creates a "wireless bubble" in exterior spaces, such as patios and outdoor cafs. Power over Ethernet (PoE) support makes it easy to install, and you can create multiple basic service set identifiers (BSSIDs) that connect to individual VLANs to keep your traffic separated.

The Cisco WAP200E is also ideal for use as a bridge to connect remote areas. For example, it could be used to connect offices with a warehouse housed in a separate building, or to connect the buildings of a college campus. Installing one access point on each building provides connections at up to Wireless-G speeds - with no cable to run. The weather-resistant housing protects the access point and is lightning protected.

To protect your data and privacy, the Cisco WAP200E supports both Wired Equivalent Privacy (WEP) and the industrial-strength wireless security of Wi-Fi Protected Access (WPA), encoding all of your wireless transmissions with powerful encryption. The MAC address filter lets you decide who can access your wireless network, and advanced logging keeps you apprised of access attempts. Configuration is a snap with the web browser-based configuration utility.

RangeBooster technology, a compatible add-on to standard Wireless-G, can nearly double the range of your wireless network and increase its throughput by up to 35 percent. Unlike ordinary wireless technologies that are confused by signal reflections, RangeBooster uses two smart receivers at each end to detect and decode reflected signals at distances where standard technologies give up. You'll find that "dead spots" in the wireless coverage area are reduced as well.

The integrated quality of service (QoS) features provide consistent voice and video quality on both the wired and wireless networks, enabling the deployment of business-quality voice over IP (VoIP) and video applications.

Additional features such as multiple BSSIDs, wireless roaming, and auto-channel selection make the Cisco WAP200E ideal for your business.


  • Lightning-protected, weather-resistant housing
  • 10BASE-T/100BASE-TX Ethernet port, auto-sensing half/full duplex, and automatic medium dependent interface (MDI) and MDI crossover (MDI-X)
  • Built-in 6-dBi directional antenna with 1x2 multiple-input, multiple-output (MIMO) to increase coverage
  • Obtains power via 802.3af PoE from a PoE switch or power injector
  • Simplified web interface for installation and configuration
  • 802.1X RADIUS authentication
  • Supports WEP, WPA Pre-Shared Key (WPA-PSK), WPA2-PSK, WPA Enterprise, andWPA2 Enterprise wireless security
  • Supports four BSSIDs and 802.1Q VLAN to service set identifier (SSID) mapping
  • Supports Simple Network Management Protocol (SNMP) and uses an intuitive web-based interface
  • Supports Wi-Fi Multimedia (WMM) wireless QoS
  • Supports wireless roaming based on 802.11F (Inter-Access Point Protocol [IAPP])
  • Offers access point, bridge mode, and repeater mode
  • Supports wireless security monitoring (working together with Cisco WMP200, WPC200, and WUSB200 adapter cards)
  • Supports wireless client isolation
  • Limited lifetime warranty



IEEE 802.11g, IEEE 802.11b, IEEE 802.3, IEEE 802.3u, IEEE 802.3af (PoE), 802.1p (QoS priority), 802.1Q (VLAN), 802.1X (security authentication), 802.11i ready (security WPA2), 802.11e ready (WMM and unsolicited automatic power save delivery [U-APSD]), 802.11F (wireless roaming)


1 Ethernet, 1 external antenna



Cabling type

Unshielded twisted pair (UTP) Category 5


Power, Ethernet, Wireless

Operating system



Web user interface

Built-in web user interface for easy browser-based configuration (HTTP/HTTPS)

Static IP


Dynamic Host Configuration Protocol (DHCP) client



SNMP versions

1, 2, and 2c

Event logging


Web firmware upgrade




Operating Modes

Access point

Access point mode, point-to-point bridge mode, point-to-multipoint bridge mode, repeater mode



802.11b/direct sequence spread spectrum (DSSS), 802.11g/orthogonal frequency division multiplexing (ODFM)

Data rates

802.11b: 1, 2, 5.5, 11 Mbps; 802.11g: 6, 9, 11, 12, 18, 24, 36, 48, 54 Mbps


11 North America, 13 Europe (ETSI and Japan) auto-channel selection

Number of internal antennas

2 at 6dBi (directional)

Antenna connector type

Reverse polarity female N-type

Detachable antenna

Yes (sold separately)

RF power (Effective Isotropic Radiated Power [EIRP])

802.11g: typical 16.5dBm, 802.11b: typical 17dBm

Antenna gain

Internal antenna: 6dBi

Adjustable power


Receiver sensitivity

802.11g: 54Mbps at -65dBm, 802.11b: 11Mbps at -85dBM



WEP, WPA-PSK, WPA2-PSK, WPA Enterprise, WPA2 Enterprise

Connection control

Wireless connection control: MAC based

SSID broadcast

SSID broadcast enable/disable


IEEE 802.1X support

Wireless client isolation

Wireless client devices can be isolated from each other either within an SSID or between 2 SSIDs; both isolation modes can be enabled at the same time.

Web-based utility access control

HTTP/HTTPS, wireless client web GUI access control

Wireless Security

WEP bits

64, 128

WPA bits and parameters

128 - Temporal Key Integrity Protocol (TKIP)/Advanced Encryption Standard (AES)

WPA2 bits and parameters

256 - AES

SSID broadcast on/off


Client isolation


MAC-based wireless connection control


Wireless web GUI access on/off


Quality of Service


4 queues
WMM wireless traffic prioritization


Wireless roaming based on IAPP (802.11F)
Auto-channel selection



W x H x D

6.42 x 8.07 x 2.17 in.

(163 x 205 x 55 mm)

Unit weight

2.47 lb (1.121 kg)

Mounting options

Industrial-strength, weather-resistant housing, lightning protection for outdoor enclosure, ceiling or wall mountable


48V DC
Maximum power draw: 4.8W

PoE in




Operating temperature

-4 to 140F (-20 to 60C)

Storage temperature

-4 to 140F (-20 to 60C)

Operating humidity

5% to 95%, noncondensing

Storage humidity

5% to 95%, noncondensing

Package Contents

Cisco WAP200E Wireless-G Exterior Access Point
User guide on CD-ROM
Mounting plate with hardware
12-foot weather-resistant network cable
Registration card

Minimum Requirements

802.11b or 802.11g wireless adapter with TCP/IP installed per PC
Switch/router with PoE support or PoE injector
Web-based configuration: Java-enabled web browser

Product Warranty

Limited lifetime hardware warranty with return to factory replacement.



No additional files, specification sheets, guides or documentation found for product.

Warranty: Lifetime Manufacturers Warranty (Return To Base)

Full manufacturers warranty details are available at the manufacturers (Cisco) web site.

Unless otherwise specified Techbuy is normally your first point of contact for warranty related returns, further information regarding our warranty policies and consumer guarantees is available on our policies and service & support pages.

To apply for return of a product just go to our returns page.

These terms are in addition to and do not affect any terms, conditions, guarantees and warranties implied by law.

Visitor Reviews

[ There are no visitor reviews for this product yet]

Review Product
Click on a thumbnail to view it below

No related products found.

L7: 4 | TM: 6 | LM: 17 | TY: 77 | T: 259

Secure Online Shopping

We accept the following with No surcharge on VISA, Mastercard and Paypal!
Techbuy Pty Ltd 2000 - 2021 All rights reserved.
All prices shown on techbuy.com.au are in $AUD and inclusive of GST. Prices and availability are subject to change without prior notice. Images displayed are accurate to the best of our knowledge and we will not be held responsible for purchases based soley on these images. All brands and names are trademarks of their respective companies. Shipping Australia wide to all metro and regional areas (Sydney, Melbourne, Brisbane, Adelaide, Perth) and Internationally. For more information, please see our usage policies.